FillHoles

Repair an imported surface mesh that might have minor holes by filling those holes.

model.component(<ctag>).mesh(<tag>).create(<ftag>,"FillHoles");

model.component(<ctag>).mesh(<tag>).feature(<ftag>).selection();

model.component(<ctag>).mesh(<tag>).feature(<ftag>).set(property,<value>);

model.component(<ctag>).mesh(<tag>).feature(<ftag>).getType(property);

Use model.component(<ctag>).mesh(<tag>).create(<ftag>,"FillHoles") to fill small holes on surfaces (boundaries) of an imported mesh.

Use model.component(<ctag>).mesh(<tag>).feature(<ftag>).selection() to specify the faces for which the holes are filled. If you do not specify the selection, it is left empty.

The following properties are available:

Table 4-41: Available Properties for FillHoles
Property	Value	Default	Description
createdom	on \| off	off	Specify if to create domains for each (connected) finite void region.
fillholestol	auto \| manual	auto	Use an automatic or manual tolerance for the maximum perimeter of a hole to be filled.
join	on \| off	on	Join with filled holes.
perimeter	double scalar	0.01	The maximum perimeter of a hole to be filled when fillholestol is set to manual.